CYLINDER GP-TILT 3672258 - Caterpillar

Move the SIO cabinet onto the mounting cleats. Reference Illustration 35.
Bolt the SIO cabinet to the mounting cleats using hardware (4111972) 1/2-13X2.5 cap bolts (2), (40258) Washer, Split Lock 1/4 inch (4), and (40179) Washer, Flat 1/2 Inch found in the SIO Cabinet Installation Hardware kit on the right rear of the main SIO cleat.
Bolt the SIO to the mounting cleats.
Replace the front kickplate and retained hardware.The mounting of the SIO Cabinet is complete.Bolting SIO to FPU
The SIO frame must be bolted to the FPU frame with the bolts provided in the 461-5641 Finishing Installation Hardware Kit. The kit has the eight (8) hex head 1/4 inch bolts (40496) that are required to bolt the SIO and FPU frame uprights together.Note: The grounding passes from the SIO ground bus and passes ground through to FPU via the joined frames.To bolt the SIO and the FPU together, perform the following steps:
Bolt the front uprights of the SIO and FPU cabinets together with the eight (8) hex head 1/4 inch bolts (PN 40496).
Illustration 36 g06027020
SIO to FPU vertical frame bolt locations
(48) SIO to FPU frame bolting sides
Illustration 37 g06027023
(49) SIO to FPU vertical frame matching sides bolt locationsNote: Only the front uprights are bolted together. See Illustrations 36 and 37.Securing Fan Shrouds
The internal SIO fan cooling duct must be bolted to the FPU and SIO are bolted together.
Illustration 38 g06027026
SIO to FPU cooling duct bolts to FPU flywheel fan shroud
(50) SIO to FPU cooling duct
Illustration 39 g06027030
FPU location of the SIO to FPU duct
(51) FPU location of the SIO to FPU ductWIRING CONSIDERATIONS
Wire the UPS750 in accordance with the drawings provided and the following procedures. Determine AC currents for the system based on kVA, voltage, and options. Also refer to equipment nameplates for the model number, rating, and voltage.Note: The system should be installed per national and local codes.
CAUTION: The weight of the power cables has to be adequately supported to avoid stress on the bus bars and lugs.
CAUTION: All power connections must be completed by a licensed electrician experienced in wiring this type of equipment. Wiring must be installed in accordance with all applicable local and national codes. Improper wiring causes damage the equipment, or injury to personnel. Verify that all incoming high and low voltage power circuits are de-energized and locked out before installing cables or making electrical connections.Observe the following requirements:
CAUTION: Underwriters Laboratories requires that a 60-Hz product must be installed with an appropriately rated service disconnect device for the output power (not supplied). If required by local and/or national regulations, an appropriately rated service disconnect device for input and output power must be provided.1 - All shielded cables, non-shielded cables, non-shielded control wires, and non-shielded remote control wires must be housed in individual, separate conduit or cable tray. Placing multiple cables in the same conduit with other control or power wiring may cause system failure.2 - Observe local, state, and national codes. Verify that utility power, and the overcurrent protection rating, will accommodate the UPS input rating.3 - Unless