CYLINDER & MTG GP-STEERING 3680561 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that all components are clean and free from wear or damage. Refer to Specifications, "Rocker Shaft" for more information. If necessary, replace any components that are worn or damaged.
Illustration 1 g01521630
If necessary, install nuts (9) and adjusters (10) to rocker arm assemblies (3) and rocker arm assemblies (4). If the original adjusters are reused, ensure that the adjusters are installed in the original positions.
Illustration 2 g01633015
Install spring (7) to the front end of rocker shaft (5) and install retaining clip (8).
Illustration 3 g01631213
Lubricate the bores of rocker arm assemblies (3) and rocker arm assemblies (4) and rocker shaft (5) with clean engine oil.
Install rocker arm assembly (3) for number 1 inlet valve to the rocker shaft. Install rocker arm assembly (4) for number 1 exhaust valve to rocker shaft (5). Note: The rocker arm assembly for the inlet valve is longer than the rocker arm assembly for the exhaust valve. Used components should be installed in the original location.
If necessary, ensure that locator (2) is correctly seated in pedestal (1). Ensure that the counterbores for the holes in rocker shaft (5) are upward. Align locator (2) with the hole to the front of rocker shaft (5). Install the pedestal to the rocker shaft.
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spring (6) to rocker shaft (5).
Repeat Step 5 through Step7 in order to assemble the remaining components to rocker shaft (5).
Install spring (7) to the rear end of rocker shaft (5) and install retaining clip (6). End By:
Install the rocker shaft assembly. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".