CYLINDER GP-RIPPER 3742285 - Caterpillar

Be sure all wheel and mounting rim surfaces are free of grease and oil before assembly. Put 2P2506 Lubricant on faces of washers and threads of nuts (8) and bolts (1) before assembly.(1) Torque for the nuts that hold spindle housing to the axle housing ... 525 20 lb.ft.(715 25 N m)(2) , (3) Tighten large nut (2) on valve stem to ... 190 10 lb.in.(21.5 1.1 N m) then tighten small nut (3) to ... 75 5 lb.in.(8.5 0.6 N m)(4) Torque for studs ... 110 15 lb. ft.(149 20 N m) Torque for nuts on studs ... 320 15 lb. ft.(425 20 N m)(5) Torque for nuts ... 40 5 lb.ft.(55 7 N m)(6) Lockwire must not pass over the heads of bolts.(7) Torque for bolts that hold plate to the cover ... 25 5 lb.ft.(35 7 N m)(8) Torque for nuts that hold anchor housing to spindle housing ... 515 20 lb.ft.(700 25 N m) Torque for the studs in the anchor housing ... 170 20 lb.ft.(230 25 N m)(9) Torque for inner and outer dual retaining nuts ... 890 40 lb.ft.(1205 55 N m)(10) Shaft diameter (new) ... 3.5128 .0004 in.(89.225 0.010 mm)(11) Inside diameter of gear (new) ... 5.0919 .0008 in.(129.334 0.020 mm) Shaft diameter and gear inside diameter measurements must be made where roller bearings make contact.