CYLINDER AS-LIFT 3944403 - Caterpillar

Illustration 1 g00877335
(1) Mode Scroll Switch (2) Increment / Hold / Clear / Store Switch
Illustration 2 g00878041
(3) Submode Number (4) Accepted Symbol (5) Not Accepted SymbolThe calibration of the front steer is performed with the engine ON. Always do all the calibrations of the front steer (full right, centered, full left).
Move the switch for the steering mode to the FRONT position. Engage the parking brake while this calibration is being performed.
Turn the key start switch to the ON position. Start the engine.
Check that the alert indicator for the machine ECM on the Caterpillar Monitoring System is NOT flashing.Expected Result: The alert indicator for the machine ECM is FLASHING.Yes - The ECM is reporting a fault at this time. The fault must be corrected prior to performing calibrations. See Troubleshooting, "Diagnostic Code Procedures".No - The machine ECM is not reporting a fault at this time. Proceed to Step 4.Note: If a service code of CID 743 FMI 13 is present, these procedures may correct the fault. Proceed to Step 4.
Enter calibration mode (mode 6) of the Caterpillar Monitoring System. In order to enter the calibration mode, press and hold the mode scroll switch (1). Release the switch when "-6-" is showing in the display area.
Enter submode c06. In order to enter the submode, press and hold the Increment / Hold / Clear / Store switch (2) in the INCREMENT position. Release the switch when submode number "c06" (3) is showing.
Use the steering wheel in order to move the front wheels to the FULL RIGHT position.
Store the value of the signal that is sent from the position sensor for the front wheel. In order to store the value, press and hold the Increment / Hold / Clear / Store switch (2) in the STORE position. While the switch