CYLINDER AS-STEERING 4170585 - Caterpillar

Single Flange
Illustration 1 g03326829
Table 1
Specification for 196-9955 Track Roller Gp
Item Qty Part Specification Description
- - - End play (clearance) of the roller shaft:
Minimum 0.26 mm (0.010 inch).
Maximum 1.26 mm (0.050 inch).
1 12 241-1855 Bolt Torque to 135 20 N m (100 15 lb ft).
2 2 162-7862 Duo-Cone Seal Gp Make sure that the rubber toric seals are clean and dry. Make sure that all surfaces that contact the toric seals are clean and dry. Apply a thin film of oil to the contacting surfaces of the metal seal. Align the Seal rings squarely with the bore. The toric ring must not bulge and the toric ring must not be twisted. Refer to Special Instruction, SEHS8364, "Assembly and Installation of Conventional Duo-Cone Seals".
3 2 7J-2036 O-Ring Seal Lubricate with the lubricant that is being sealed.
4 2 9W-9844 Bushing Bore after assembly is 114.55 0.04 mm (4.510 0.002 inch).
Installation depth is 13.5 0.5 mm (0.53 0.02 inch).
A - - Install each collar from each end of the track roller shaft to is 57.92 0.13 mm (2.280 0.005 inch).
B - - Installation depth for installing the stopper assembly below the end of the track roller shaft is 11 4 mm (0.4 0.2 inch).
C - - Note: The clear plug must not be recessed below the surface of the stopper assembly.
Install the clear plug so that the end is even with the stopper assembly. The clear plug can extend up to 0 to 5 mm (0.0 to 0.2 inch) out of the stopper assembly.
5 4 6T-1140 Bolt Torque to 750 70 N m (553 52 lb ft).