CYLINDER & SEAL GP-STICK 4172656 - Caterpillar

Illustration 4 g01109835
Select "Implement (for the machine that is being serviced)" from the "ECM Selector" screen and click on the "OK" button.
Illustration 5 g01109846
Select "Service" menu in the ET. Select "Calibrations" from the "Service" menu. Select "Lever Calibrations" from the "Calibrations" menu.
Illustration 6 g01171796
The screen will display all the control levers that are available on the machine. Once you have selected the control levers to calibrate, select the "Begin" button. The screen will change in order to display step-by-step instructions for calibrating the control lever. Note: The ET software defaults so that all the control levers will be selected for calibration. Select the check mark button next to an individual control lever in order to remove a control lever from the calibration procedure.
Illustration 7 g01109852
Select the "Next" button in order to begin the calibration. Follow the directions that are shown on the screen. A check mark button will be placed to the left of a completed step and the next step will be highlighted in bold text. After successful completion of a step, you may need to select the "Next" button in order to begin the following step. Follow the steps that are listed in the bottom section of the screen until the calibration procedure is complete. Note: The ET screen will be divided into three display areas. The top section of the screen will be used to display important status parameters that are monitored during the calibration. The middle section of the screen displays the information about the calibration procedure. The bottom section of the screen displays the step-by-step instructions for the calibration. The step that currently needs to be performed will be in bold text. All other steps will be displayed in gray text.
Illustration 8 g01109859
If the machine is equipped with detent coils, the magnets will hold the lever in the DETENT position.
Illustration 9 g01171814
When the calibration is complete, ET will display a status screen. The status screen will inform you that the calibration of the lift control lever was successful. Select the "Continue" button in order to go to the next calibration or the "Cancel" button in order to end the calibrations.
Illustration 10 g01109861
Select the "Next" button in order to begin the next calibration. Follow the directions on the screen.
Illustration 11 g01109865
Illustration 12 g01171821
When the calibration is complete, ET will display a status screen. The status screen will inform you that the calibration of the tilt control lever was successful. Select the "Restart" button in order to repeat a sensor calibration or press the "Finish" button in order to exit the status screen.
The implement (ECM) will store the new calibration data when the calibration is successful. Note: If the "Third Function Enable Status" is enabled, the auxiliary function must be calibrated. The status of the "Third Function Enable Status" can be viewed from the configuration screen.Note: The third function and the auxiliary function are the same function.Note: If the "Third Function Enable Status" has just been enabled through the configuration screen, ensure that the key start switch has been turned to the OFF position