CYLINDER & SEAL GP-STICK 4185513 - Caterpillar

and Maintenance Manual , "Maintenance Recommendations" .Unless other instructions are provided, perform maintenance and perform repairs under the following conditions:The starting system is disabled.The engine is stopped.The generator does not pose an electrical shock hazard.The generator is disconnected from the load.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant Extender (ELC) - Add
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Generator - Dry
Generator Set - Test
Daily
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every 600 000 L (158 500 US gal) of Fuel
Overhaul (Top End)
Every Week
Automatic Start/Stop - Inspect
Battery Charger - Check
Generator - Inspect
Generator Bearing Temperature - Test/Record
Overhaul
Overhaul Considerations
Initial 250 Service Hours
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Every 250 Service Hours or 6 Months
Battery Electrolyte Level - Check
Engine Oil Sample - Obtain
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Every 500 Service Hours or 1 Year
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Every 2000 Service Hours or 1 Year
Engine Crankcase Breather - Clean
Generator Lead (Round Cable) - Check
Generator Set Vibration - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Engine Performance - Test
Rotating Rectifier - Check
Every 3000 Service Hours or 3 Years
Alternator - Inspect
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Rotators - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 4500 Service Hours
Generator Bearing - Lubricate
Commissioning
Generator Set Alignment - Check