CYLINDER GP-SWING 4203698 - Caterpillar

Table 1
Test Equipment Quantity
Digital Level 1
Survey Paint 1
Person 1
Two-way Radios 2 Machine Preparation
Note: Prior to performing this procedure ensure that all components are installed in the appropriate positions. Adjust the camera angles in order to obtain the best view of coverage areas.
Park the machine in a wide open area that is large and level. This area should have 15 m (49 ft) of clearance to the front and 15 m (49 ft) of clearance to the rear of the machine.
Set the parking brake.
Turn the disconnect switch to the ON position
Start the machine.
Verify that the system is powered up and the system status indicator and the system fault indicators are illuminated green on the display.
While the machine is parked in the large wide open area check for any surrounding obstacles like bumps, and so on, by observing the display for any flashing areas in the object detection sensor detection area. The situations that are listed in Table 2 can cause false objects to be detected and are listed in order of precedence:
Table 2
Description of Cause Resolution
Test area is not level, area in front or rear of machine has an uphill slope. Find a test area that is more level or reposition the area of the machine being validated to face the area with the down hill slope to calibrate the system. Do not use an area with too great of slope (2 to 3 percent max) to validate the system.
The object detection sensor angle is too low and is detecting ground reflections. The object detection sensor angles provided in the installation information were determined to be the optimum angles for installation, however due to installation variations and differences in machines the actual angle may require adjustment. Refer to Systems Operation Troubleshooting Testing and Adjusting, UENR5154, "Object Detection Sensor - Adjust" section of this manual for additional information
There is mud or some other type of debris blocking the sensor. Clean the object detection sensors to eliminate the issue. Calibrate Procedure
The calibration process consists of a person referred to as the object being moved into and out of the object detection sensors coverage area. The person moving the object will be told to stop via radio whenever the object appears or disappears on the display. This procedure is performed in order to determine the limits of the coverage area and any identify holes that may exist in the coverage area. In the case that the limits of the coverage area are inadequate, adjustments will need to be made to the angles of the object detection sensors and the brackets of the object detection sensors. This procedure will be performed for the following areas of the machine:
Front
RearFront and Rear of the Machine
The Object Detection System is designed to enhance the operators awareness of the operators surroundings. Use of this system does not replace basic safety precautions and procedures for operating the machine. Refer to the Operation and Maintenance Manual of the machine for additional information.
Illustration 1 g03424517
Maximum Range for pickup trucks or 55