CYLINDER GP-TILT 4203700 - Caterpillar

Hydraulic accumulator contains gas and oil under high pressure. Improper removal or repair procedures could cause severe injury. To remove or repair, instructions in the service manual must be followed. Special equipment is required for testing and charging.
Personal injury or death can occur if steering is lost completely during operation.Do not continue to operate the machine using the secondary steering.If the secondary steering activates during operation, immediately park the machine in a safe location. Inspect the machine and correct the condition which made the use of the secondary steering necessary.
This machine is equipped with a secondary steering system. The hydraulic steering accumulators provide a limited amount of stored hydraulic pressure for steering if the power source for the normal steering system fails or the engine stops. The secondary steering system will only provide steering until the stored hydraulic pressure is exhausted from steering action by the operator.
Illustration 1 g03425618
(1) Steering accumulators Perform the following field test in order to verify that the secondary steering system is functional. Perform the test when the dump body is empty.
Prepare the machine for maintenance. Refer to Operation and Maintenance Manual, "Prepare the Machine for Maintenance".
Turn the front wheels to the straight ahead position.
Chock the rear wheels and move the shift control lever in the N position.
Refer to Operation and Maintenance Manual, "Hydraulic Tank Oil Level - Check (Brake, Steering, and Hoist)" for more information.
Illustration 2 g03425619
Stop the engine by pressing ground level shutdown switch (push button) (3).
Illustration 3 g03459659
Move the MASTER switch to the OFF position. Note: Pressing the ground level shutdown switch (push button) and turning off the MASTER switch permits the accumulators to stay charged in order to provide stored energy for the secondary steering system when the engine is stopped.
Visually confirm the following:
Verify that the front wheels turn left as the steering wheel is turned left.
Verify that the front wheels turn right as the steering wheel is turned right. If the secondary steering system is unable to comply with any portion of this field test, refer to Troubleshooting, System Operation, Testing and Adjusting, UENR2985, "MT4400D AC Off-Highway Truck Steering System", "Accumulator (Steering) - Test and Charge" or consult your Cat dealer.