CYLINDER GP-HYDRAULIC 4261418 - Caterpillar

4261418 CYLINDER GP-HYDRAULIC Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4261418
426-1418
4261418

Caterpillar 4261418 CYLINDER GP-HYDRAULIC

Buy CYLINDER GP-HYDRAULIC 4261418 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:

Caterpillar 4261418 Parts scheme CYLINDER GP-HYDRAULIC

For full view, you need register

Information:

Illustration 4 g00850310
Install bolt (30) and the washer. Repeat this procedure for the opposite side.
Illustration 5 g00850307
Left Side View
Install bolt (29) and the washer.
Illustration 6 g00850304
Right Side View
Install bolt (28) and the washer.
Remove the hoist, lifting chains, and Tooling (A) .
Illustration 7 g00850300
Connect hose assembly (27) .
Illustration 8 g00850296
Connect hose assembly (22) to top radiator tank (24) .
Connect hose assembly and tighten clamp (23) .
Connect hose assembly and tighten two clamps (25) .
Slide the rubber sleeve toward the rear of the machine in order to connect the tube assembly. Tighten two clamps (26) .
Illustration 9 g00850293
Connect electrical connector (20) .
Install bolt (21), the washer, and the clamp.
Illustration 10 g00850292
Connect hose assemblies (17), (18), and (19) .
Illustration 11 g00850288
Typical Example
Close access door (16) .
Illustration 12 g00850281
Connect three hose assemblies (15) .
Illustration 13 g00850276
Connect two tube assemblies (14) .
Tighten two clamps (13) .
Illustration 14 g00850273
Slide sleeve (11) in order to connect tube assembly (10). Tighten four clamps (12). Repeat this procedure for the opposite side.
Illustration 15 g00850272
Install plate (9) .
Install hose assembly (7). Tighten two clamps (6) .
Install bolt (8) and the washer. Repeat this procedure for the opposite side.
Illustration 16 g00850262
Illustration 17 g00850261
Attach a suitable hoist and lifting slings to cover (4), as shown.
Use the hoist in order to install cover (4). The weight of the cover is 45 kg (100 lb).
Install bolts (1) and (2), the spacers, and the washers finger tight.
Remove lifting slings (3) and (5) .
Tighten bolts (1) and (2) .
Fill the hydraulic tank to the proper level. Refer to the appropriate Operation and Maintenance Manual for the correct procedure.End By: Install the front and rear hood panels. Refer to Disassembly and Assembly, "Hood Panels (Front and Rear) - Install" for the machine that is being serviced.