CYLINDER AS 4327308 - Caterpillar

Illustration 25 g00785532
Install bolt (25), bearing (26), spacer (27), nut (28), the lockwasher, and the shock absorber, as shown.
Illustration 26 g00785534
Install bolt (29), nut (30), spacer (31), bearing (32), and the lockwasher to the other end of the shock absorber, as shown.
Illustration 27 g00785503
Illustration 28 g00785518
Install two bolts (22), two nuts (24), and the washers.
Install two new cable straps (23) .
Illustration 29 g00785515
Illustration 30 g00785512
Install bumper (21), the nut, and the retainer.
Install lower housing (19). Align both ends of the scissors through slots (20) in order to install lower housing (19), as shown.
Illustration 31 g00785501
Install rod (17), locknut (18) (not shown), and the washer to the suspension.
Illustration 32 g00785511
Be sure that mounting bracket (16) is properly installed on compressor (14) .
Illustration 33 g00785506
Illustration 34 g00785404
Install compressor (14) and two bolts (13) to the suspension.
Connect hose assemblies (11) and (12) to compressor (14). Connect cable strap (15) to the suspension.
Install new cable straps to the original locations. This will help to ensure that all hose assemblies and harness assemblies will not get damaged during the operation of the suspension.
Illustration 35 g00785399
Install two threaded blocks (8) (not shown). Install four bolts (9), the washers, and two straps (10) to threaded blocks (8) (not shown).
Illustration 36 g00785393
Install boot (7), fasteners (6), and acorn nut (5) .
Illustration 37 g00785385
Install blocks (4) to the original positions on the suspension. The seat will not align properly, if the blocks are not installed to the original locations.
Install the seat to the suspension.
Illustration 38 g00785382
Install stop block (3), two bolts (2), and the washers to the suspension.