CYLINDER GP-ANGLING 4344591 - Caterpillar

Retarder Speed Control Button (27)
Automatic Retarder Control (ARC) (27) - Pull the button switch to select the ON position for the ARC system. This sustains the machine at a constant speed on a downgrade. If necessary, use dynamic retarding control pedal (12) in order to apply more retarding force during the operation of the ARC system. Push the button switch in order to select the OFF position for the ARC system. The ARC should remain in the ON position during normal operation. For more information, refer to Operation and Maintenance Manual, "Retarding".Service Ports
Illustration 3 g03422332
(28) ET service port
(29) VIMS service port ET Service Port (28)
ET Service Port (28) - This service port allows service personnel to connect a laptop computer that is equipped with the Electronic Technician (ET). This will allow service personnel to diagnose the machine systems and this will allow service personnel to program system parameters.VIMS Service Port (29)
VIMS Service Port (29) - This service port allows service personnel to connect a laptop computer with the software for VIMS 3G.Note: The engine lockout control will allow power to the ECM in order to provide an active VIMS service port.Ground Level Controls
Illustration 4 g03420866
The ground level control box is located on the right side of the front bumper near the base of the stairs.
(1) Battery disconnect switch Battery Disconnect Switch (1)
Battery Disconnect Switch (1) - See Operation and Maintenance Manual, "Battery Disconnect Switch".Ladder and Engine Compartment Lights
Illustration 5 g03440976Switch for Access Lights
Switch for Access Lights (2) - Use this switch in order to turn on or turn off the lighting in the area around the stair assembly.Note: There are two switches that activate these lights. One switch is located in the cab and the other switch is located on the ground level controls near the bottom of the stair assembly. The position of one switch will determine whether the other switch is in the ON position or in the OFF position.Engine Compartment Lights
Engine compartment Lights (3) - Use this switch in order to turn on or turn off the lighting in the area around the engine compartment.Engine Shutoff Switch (Push Button)
Engine Shutoff Switch (Push Button) (4) - The engine shutdown switch (Push Button) is depressed to stop the engine. Pull the switch (push button) to reset the engine.Dash Panel Controls
Panel Dimmer (1)
Illustration 6 g03439518
Panel Dimmer (1) - Press the left button momentarily to illuminate panel. Use both buttons to set desired level of brightness.