CYLINDER HEAD AS 4630918 - Caterpillar

Illustration 1 g01228183
Operator controls
The intermittent saw button sends a current output to the control valve that is located on the base of the boom. The single current output will drive two solenoids simultaneously. The control valve section contains signal limiter valves in order to set the pressure for a specific saw. The signal limiter valves are adjustable for different saws.Note: Refer to the IQAN display or the Operation and Maintenance Manual for the control pattern of the intermittent saw buttons for your machine.Manual saw return button may not be used in all applications. Manual saw return button sends a signal to the control valve which shifts one of the valve sections in the opposite direction. Manual saw return button is also a current output that can adjust the flow to the functions of the saw. However, the intermittent saw valve uses the main pump flow.
Illustration 2 g01070033The control valve for the intermittent saw is located on the back of the boom.
Illustration 3 g01059628
Control Valve (Intermittent Saw)
(1) Inlet section
(2) Left control valve
(3) Right control valve
(4) Air purge valve
(5) End section
(6) Main relief valve
(7) Proportional solenoid valve
(8) Proportional solenoid valve
(9) Proportional solenoid valve
(10) Proportional solenoid valve
(P1) Pump port
(T1) Tank port
(A) Port (left control valve)
(A) Port (right control valve)
Illustration 4 g01472972
Hydraulic Schematic of the Control Valve
(1) Inlet section
(2) Left control valve
(3) Right control valve
(5) End section
(6) Main relief valve
(7) Proportional solenoid valve (reverse left)
(8) Proportional solenoid valve (forward left)
(9) Proportional solenoid valve (reverse right)
(10) Proportional solenoid valve (forward right)
(11) Orifice
(12) Orifice
(13) Signal duplication valve
(14) Pressure compensator valve (left)
(15) Valve spool
(16) Pressure compensator valve (right)
(17) Valve spool Main relief valve (6) has been completely closed. The main relief and the load sensing is controlled by the travel control valve. Reference: See Systems Operation/Testing and Adjusting, "Relief Valve (Main, Load Sensing) - Test and Adjust" for more information.If air enters the pilot hydraulic system the valve spools may not move smoothly. The air can be removed from the system through air purge valve (4) when the engine is running.