CYLINDER AS 4953722 - Caterpillar

Illustration 22 g01171605
Autoshift control switch (A) Ride control switchNote: A connector for the ride control is available on the harness inside the switch panel. If the customer wants this function, the customer will need to order the correct switch. The customer will need to place the switch in the unused slot.Lift Control
Illustration 23 g01171609
Lift control lever (A) There is no fine modulation for the 980GSeries II with the underground mining arrangement.Tilt Control
Illustration 24 g01171614
Tilt control lever (A) There is no fine modulation for the 980GSeries II with the underground mining arrangement.Kickout and Positioned Control
Illustration 25 g01171615
Kickout and Positioned Control switch (A) Kickout and positioned control switchHood
Note: The hood does not tilt on the 980GSeries II with the underground mining arrangement. Service the Cab Air Filter
Illustration 26 g01171617
Cab Air Filter (A) Bolts (B) Filter
Remove the two bolts (A) and remove the filter cover that is on the right side of the seat.
Remove the filter element (B) .
Clean the filter element with air pressure or wash the filter element in warm water with a nonsudsing household detergent.
If water and detergent are used in order to clean the filter element, rinse the filter element in clean water and allow the filter element to air dry thoroughly.
Inspect and replace the filter if the filter is damaged.
Reinstall the filter element.
Reinstall the filter cover.Circuit Breaker Reset
Illustration 27 g01171620
Circuit Breakers (A) Main circuit "80 A" (B) Alternator "105 A" (C) Engine shutdown "15 A" (D) Electrical circuits in Cab "20 A" (E) This circuit breaker is not used for the 980GSeries II with the underground mining arrangement. Replace the Biodegradable Hydraulic Oil Filter element
Illustration 28 g01171626
(A) Bolts (B) Cover
Remove the four bolts (A) .
Remove the cover (B) in order to gain access to the oil filter element.Replace the Transmission Oil Filter
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Open the small access door. The transmission oil filter is located on the right side of the machine.
Illustration 29 g00768695
Open the shutoff valve (2) and allow the oil to drain into a suitable container.
Use a strap type wrench in order to remove the transmission filter housing (1) .
Remove the used transmission oil filter element. Dispose of the used filter element properly.
Clean the transmission filter housing in a clean, nonflammable solvent. Clean the filter housing base.
Inspect the filter housing seal. Replace the seal if the seal is damaged.
Insert a new transmission oil filter element into the transmission filter housing.
Close the shutoff valve. Install the transmission filter housing into the filter housing base. Tighten the transmission filter housing by hand.
Start the engine. Apply the service brakes.
Slowly operate the transmission controls in order to circulate the transmission oil. Return the transmission to NEUTRAL.
Engage the