CYLINDER GP-BOWL 4T5735 - Caterpillar

Image1.1.1
Image1.1.2
Image1.1.3
3. Connect the 291-2430 Harness As to the 291-2431 Harness As that was just installed on the machine. At the boss location where the two new harnesses connect, install a 130-5300 Clip using existing hardware to hold the DT connection to the machine.
4. Install the rest of the 291-2430 Harness As over the top of the tractor hitch and gooseneck. Use (8) 8T4896 Washers, (4) 5S7379 Bolts, and (4) 6V-8801 Nuts for installing the (4) 6D3479 Clips located on top the hitch where the tractor and scraper are pinned.
5. Use (1) more 6D3479 Clip and existing hardware at the clipping point on top of the scraper gooseneck.
6. Finish installing the harness by connecting the sure-seal connector at the other end of the harness, using the existing hardware and sure-seal clip.
Image1.2.1
Group Number 2
615C II Wheel Tractors
The procedure below will replace the existing 2T3310 Harness As with two new harnesses, 291-2432 Harness As and 291-2433 Harness As.
1. Remove the existing 2T3310 Harness by uninstalling the mounting clips, zip-tie straps, and hose guard from the machine. Do not discard the mounting hardware for any of the clipping locations.
2. Next, route the 291-2433 Harness As over the front of the tractor hitch, and running it under the right side of the cab, as the previous 2T3310 Harness As was routed. Also, connect the 291-2433 Harness As to the same sure-seal connections as used by the previous harness.
Note: When connecting the sure-seal harness connections on the machine, the sure-seal covers on the new harnesses may need to be pulled back to allow the harnesses to mate securely when connecting them together.
Image2.1.1
3. Install the 192-2887 Guard on the top portion of the new 291-2433 Harness As. Finish installing the new harness and guard using (3) new 3S8665 Clips near the front left hand corner of the hitch and on the tractor frame using existing hardware. The third and top boss on the front left corner of the tractor hitch will not have a P-clip but will use a 130-5300 Clip to hold the DT connectors between the new harnesses once they both are installed. Install the (20) 7K1181 Straps to finish securing the guard over the new harness.
Use (4) 6D3479 Clips and existing hardware for the clipping locations on the two brackets on top of the tractor hitch and gooseneck, where the tractor and implement are pinned.
4. Install the 291-2432 Harness As over the top of the tractor hitch and gooseneck by connecting it to the 291-2433 Harness Assemblies DT connection on the tractor hitch.
Image2.2.1
5. Use (3) more 6D3479 Clips and existing hardware at the clipping point on top of the gooseneck.
Image2.3.1
6. Finish installing the harness by connecting the sure-seal connector at the other end of the harness, using the existing sure seal clip to hold the connection.