CYLINDER GP-STABILIZER-LH 4T9911 - Caterpillar

Specifications
Illustration 1 g02689656
Table 1
Specification for 313-6235 Control Valve Gp
Item Qty Part Specification Description
1 1 317-3076 Control Valve Gp (SEQUENCE VALVE) Torque to 34 1.4 N m (300 12 lb in).
Locknut Torque to 9.5 0.5 N m (7 0.4 lb ft).
2 1 317-3073 Control Valve Gp (PARKING BRAKE CONTROL) Torque to 47.6 2.7 N m (35 2 lb ft).
3 1 344-7389 Pressure Sensor Gp Torque to 62 6 N m (46 4 lb ft).
Operating voltage is between +7 VDC to +14 VDC.
Output: PWM.
Output frequency is 500 100 Hz.
Duty cycle is between 5 and 95%.
4 3 314-9274 Solenoid Valve Gp Torque to 25.5 3 N m (19 2 lb ft).
384-8750 Coil Voltage is 24 V.
Resistance is 33.75 5% Ohms at 20° C (68° F).
Wattage is 17.07W.
Locknut Torque to 6.1 0.7 N m (54 6 lb in).
5 2 317-3075 Control Valve (SEQUENCE VALVE) Torque to 68 5.4 N m (50 4 lb ft).
6 1 317-3074 Control Valve (PARKING BRAKE CONTROL) Torque to 95.2 6.8 N m (70 5 lb ft). Removal Procedure
Start By:
Install the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Remove and Install".
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Remove the parking brake control valve. Refer to Disassembly and Assembly, "Brake Control Valve Parking - Remove and Install".Note: Cleanliness is an important factor. Before the removal procedure, thoroughly clean the exterior of the component. Thoroughly cleaning the exterior of the component will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses, and all tubes to prevent fluid loss and contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 2 g06277370
Remove brake release sequence valve (2) from manifold (1).
Remove the three O-ring seals from brake release sequence valve (2).Installation Procedure
Note: Check the O-ring seals, the gaskets,