5122360 CYLINDER & SEAL GP-STICK Caterpillar parts
Rating:
Alternative (cross code) number:
CA5122360
512-2360
5122360
CA5122360
512-2360
5122360
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Brake X Front Brake Pads and Rotors Kit with brake caliper compression tool replacement for 2009-2014 Acura TL | AEGIS GEOMET Coated Rotors and Alpha Ceramic Brake Pads
Brake X Get The Right Fit: The front replacement brakes and rotors kit are built for 2009 2010 2011 2012 2013 2014 TL || 6 Piece Brake Kit Replacement with Caliper piston compressor tool: Our Replacement brake Kit comes with 2 heavy duty rear rotors along with 4 automotive replacement brake pads that are built to exceed OEM Specification using quality materials for performance and long term use. || Quality That Matters: Our rotors and brake pads kit with brake pad spreader are engineered in Canada for the toughest environments with exact or more vane counts to meet OEM Specifications. They are backed by our satisfaction guarantee for any manufacturing defects so you know we have your back as you make every turns. || GEOMET Protected: Our front automotive replacement brake kits are made using heavy duty G3000 grade cast iron with a GEOMET coating to offer just the right balance of performance, quality and durability. It?€?s resistant to rust and corrosion, built to exceed OEM specifications, and can be installed without any modifications. || No Noise And Low Dust: We use a ceramic formula for our brake pads, they are shimmed, chamfered and slotted to ensure smoother, quieter braking and reduce braking noise. Our automotive replacement brake rotors are double disc smoothened and mill balanced to help prevent cracking and build up. The Brake X rotors and brakes are engineered to elevate your driving experience.
Brake X Get The Right Fit: The front replacement brakes and rotors kit are built for 2009 2010 2011 2012 2013 2014 TL || 6 Piece Brake Kit Replacement with Caliper piston compressor tool: Our Replacement brake Kit comes with 2 heavy duty rear rotors along with 4 automotive replacement brake pads that are built to exceed OEM Specification using quality materials for performance and long term use. || Quality That Matters: Our rotors and brake pads kit with brake pad spreader are engineered in Canada for the toughest environments with exact or more vane counts to meet OEM Specifications. They are backed by our satisfaction guarantee for any manufacturing defects so you know we have your back as you make every turns. || GEOMET Protected: Our front automotive replacement brake kits are made using heavy duty G3000 grade cast iron with a GEOMET coating to offer just the right balance of performance, quality and durability. It?€?s resistant to rust and corrosion, built to exceed OEM specifications, and can be installed without any modifications. || No Noise And Low Dust: We use a ceramic formula for our brake pads, they are shimmed, chamfered and slotted to ensure smoother, quieter braking and reduce braking noise. Our automotive replacement brake rotors are double disc smoothened and mill balanced to help prevent cracking and build up. The Brake X rotors and brakes are engineered to elevate your driving experience.
Information:
Table 1
Diagnostic Trouble Codes    
CDL Code    J1939 Code    Description
(code descriptions may vary)    Comments    
E994 (2)         Low Crankcase Pressure     The Engine Control Module (ECM) activates this code when the crankcase pressure has been below the minimum value for a programmed time period. The amber warning lamp is illuminated. The code is logged. Engine power is derated.    
Illustration 1 g02211761
Typical crankcase ventilation system (1) Crankcase pressure sensor (2) Breather (3) Filter housing (4) Fumes disposal tube
Illustration 2 g02013955
Left side of the engine (5) Check valveProbable Causes
The oil fill cap is off.
The oil level gauge (dipstick) is not fully seated.
The vent filter for the crankcase is not installed.
The tube between the breather and the breather canister is not connected.The engine is equipped with an open crankcase ventilation system. Recommended Actions
Table 2
Troubleshooting Test Steps    Values    Results    
1. Engine Ventilation
A. Establish communication between Cat® Electronic Technician (ET) and the ECM . Refer to Troubleshooting, "Electronic Service Tools", if necessary.
B. Download the "Warranty Report" from the engine ECM before performing any troubleshooting or clearing diagnostic trouble codes.
C. Inspect the engine. Look for the conditions that are listed above.
   
Ventilation
   
Result: The probable cause was found.
Repair: Make the necessary repairs.
Reset all active codes and clear all logged codes. Use Cat ET to verify that the problem is resolved.
   If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).
Caterpillar SIS machinery equipment:
Caterpillar SIS
336 Excavator YBN00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
336 Excavator JHD00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
336 Excavator GDY00001-UP (MACHINE) POWERED BY C9.3 Engine »
512-2360
CYLINDER & SEAL GP-STICK
336 Excavator DKS00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
336 Excavator SP900001-UP (MACHINE) POWERED BY C9.3 Engine »
512-2360
CYLINDER & SEAL GP-STICK
340 Excavator TYH00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
336 Excavator FEL00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
340 Excavator WDN00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
340 Excavator GMJ00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
340 Excavator TMK00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
340 Excavator SZT00001-UP (MACHINE) POWERED BY C9.3B Engine »
512-2360
CYLINDER & SEAL GP-STICK
Caterpillar parts catalog:
Parts cylinder Caterpillar catalog:
5120988
CYLINDER & LINES GP-BOOM
Caterpillar
Caterpillar
5120987
CYLINDER & LINES GP-BOOM
Caterpillar
Caterpillar
5120986
CYLINDER & LINES AR-BOOM
Caterpillar
Caterpillar
5110361
CYLINDER GP-TILT
Caterpillar
Caterpillar
5110360
CYLINDER GP-TILT
Caterpillar
Caterpillar
5107357
CYLINDER AS
Caterpillar
Caterpillar
5147587
CYLINDER GP-HYDRAULIC
Caterpillar
Caterpillar
5141513
CYLINDER GP-TILT
Caterpillar
Caterpillar
5141512
CYLINDER GP-TILT
Caterpillar
Caterpillar
5123134
CYLINDER GP-GRAPPLE
Caterpillar
Caterpillar
5122365
CYLINDER GP-BUCKET
Caterpillar
Caterpillar
5122361
CYLINDER GP-STICK
Caterpillar
Caterpillar