CYLINDER GP-TILT 5168026 - Caterpillar

Engine Cooling System
This parameter determines the configuration of the cooling system. This parameter requires a factory password to change.
Table 13
Minimum Default Maximum
SCAC SCAC JWAC Cold Mode Cylinder Cutout
This parameter enables the strategy for the cold mode cylinder cutout.
Table 14
Minimum Default Maximum
Disabled Enabled Enabled Droop
This parameter allows the engine to operate in a system of load sharing.
Table 15
Minimum Default Maximum
0.0 0.0 10 Fuel Position Multiplier
This parameter decreases the power output from the engine by reducing the fuel. This parameter is used to control the driven equipment. A decrease in engine power does not require a change in the throttle.
Table 16
Minimum Default Maximum
Disabled Disabled Enabled Engine Acceleration Rate
This parameter limits the rate of change for the desired engine speed. This parameter may also help reduce smoke when you start the engine.
Table 17
Minimum Default Maximum
1 rpm per second 250 rpm per second 2000 rpm per second Cooling Warning (Engine Load)
This parameter indicates that too much load has been added to the engine before the jacket water has reached the minimum operating temperature of 75 °C (167 °F).
Table 18
Minimum Default Maximum
5% 40% 95% Throttle
The parameter is used to decide whether the continuous throttle or the multi-position throttle will be used. Table 20 defines the speeds at various throttle positions for a multi-position throttle.
Table 19
Minimum Default Maximum
Continuous Continuous Notch
Table 20
Speed of Position Number Percent Duty Cycle Minimum RPM Default RPM Maximum RPM
Idle <10 450 600 1900
1 <20 450 700 1900
2 <30 450 1300 1900
3 <40 450 1500 1900
4 <50 450 1600 1900
5 <60 450 1675 1900
6 <70 450 1715 1900
7 <80 450 1770 1900
8 <95 450 1800 1900