CYLINDER GP-RIPPER 5218411 - Caterpillar

Removal Procedure
Start By:
Remove the tandem and the cover. Refer to Disassembly and Assembly, "Tandem and Cover - Remove and Install".
Illustration 1 g01060649
Remove bolt (1) and lock (2) . Remove nut (3) . Remove sprocket (4) . Remove sprocket (5) .Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-4204     Wrench     1    
Illustration 2 g01060649
Install sprocket (5) . Install sprocket (4) and install nut (3) hand tight.Note: Assemble so the teeth on both sprockets are not aligned (out of phase) with each other.
Tighten the nut while you rotate the shaft. Use a soft faced hammer to tap the sprockets while you tighten the nut.
Tighten nut (3) to a torque of 11.3 1.13 N m (100 10 lb in).
Loosen nut (3) by one locking position and tap the sprockets to ensure that the bearings are fully seated.
Tighten nut (3) in order to achieve a rolling torque of 3.95 1.13 N m (35 10 lb in) above the seal drag.
If nut (3) is in a locking position, install lock (2) and install bolt (1) .Note: Bolt (1) must be replaced with a new bolt.
If nut (3) is not in a locking position, tighten nut (3) to the next locking position. With nut (3) in the locking position, install lock (2) , and install bolt (1) .End By: Install the tandem and the cover. Refer to Disassembly and Assembly, "Tandem and Cover - Remove and Install".