CYLINDER GP-BUCKET 6E0091 - Caterpillar

Removal Procedure
Start By:
Activate the hydraulic system pressure release. Refer to Disassembly and Assembly, "Hydraulic System Pressure Release - Release Procedure".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00760394
Remove twelve screws (1). Remove rubber panel (2) .
Illustration 2 g00760399
Loosen two hose clamps (3). Remove two hoses (4) .
Remove brake line (5) .
Illustration 3 g00760407
Disconnect two electrical connectors (6) .
Illustration 4 g00760411
Illustration 5 g00760415
Remove two bolts and three nuts (7). Remove brake pedal mounting bracket (8) .