CYLINDER AS 6E1344 - Caterpillar

Specifications
Table 1
Specifications
Item Measurement Value
Speed Sensor Air Gap 0.89 mm (0.035 inch)
This measurement is approximately 180 degrees of sensor rotation.
Sensor Lock Nut Torque 25 5 N m (18 4 lb ft) Introduction
The following procedure for setting speed sensor air gap applies to the Engine Speed Sensor and Speed Sensor (Torque Converter Output).Adjustment Procedure
Illustration 1 g00289497
Speed Sensor
(1) Speed sensor
(2) Locknut
(A) Air gap
Remove speed sensor (1). Align a gear tooth directly in the center of the threaded sensor opening.
By hand, screw the speed sensor (1) into the hole until the end of the sensor contacts the gear tooth.
Set the air gap of the speed sensor to 0.89 mm (0.035 inch). The air gap is set by turning the sensor 180 degrees in the counterclockwise direction.
Tighten locknut (2) to 25 5 N m (18 4 lb ft).Note: Do not allow speed sensor (1) to turn as locknut (2) is tightened.