CYLINDER AS 6E5902 - Caterpillar

6E5902 CYLINDER AS Caterpillar parts 910E, IT12B

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA6E5902
6E-5902
6E5902

Weight: 21 pounds 9 kg.

Information:

BORE DIAMETER 69.9 mm

GREASE PORT N

MOUNT TYPE SPECIAL

TYPE 1

Buy CYLINDER AS 6E5902 Caterpillar genuine, new aftermarket tractor parts with delivery
COMPACT WHEEL LOADER, INTEGRATED TOOLCARRIER,

Compatible equipment models: 6E5902:

COMPACT WHEEL LOADER 910E

INTEGRATED TOOLCARRIER IT12B Caterpillar

Number on catalog scheme: 2

Caterpillar 6E5902 Parts scheme CYLINDER AS

For full view, you need register

Information:

Illustration 27 g00432139
Location Of Tractor Transmission Plug
Install a 9S-1721 Socket Extension in the end of the rotary selector spool. Install a 9U-6635 Ratchet on the extension.
Turn the tractor key start and disconnect switch ON. Do not start the engine.
Start the scraper engine and run the engine at LOW IDLE rpm.
Move the tractor transmission rotary selector spool to any speed position.
Disconnect the synchronizing solenoid harness from the solenoid.
The pressure at gauge (D) must be 690 35 kPa (100 5 psi) .
The pressure at gauges P1 (F) and P2 (G) must be 0 kPa (0 psi) .
Connect the synchronizing solenoid harness to the solenoid.
The pressure at gauge (D) must be 1820 kPa (264 psi) minimum.
Run the scraper engine up to HIGH IDLE rpm.
The pressure at gauge (D) must be 2137 138 kPa (310 20 psi) .
When the test is completed, return the tractor transmission rotary selector spool to NEUTRAL and turn the scraper engine OFF. Next, turn the tractor key start and disconnect switch OFF and remove the test equipment.Problem
The pressure in Step 12 is too low.Probable Cause
The setting of synchronizing valve (15) is too low. Add spacers (23) . Refer to Table 8 .Problem
The pressure in Step 12 is too high.Probable Cause
The setting of synchronizing valve (15) is too high. Remove spacers (23) . Refer to Table 8 .
There is a bad synchronizing solenoid (4) .Problem
The pressure on the gauges is not 0 kPa (0 psi) in Step 13 .Probable Cause
There is a bad synchronizing solenoid (4) .
Synchronizing valve (15) is stuck.
The priority valve does not operate correctly.
Illustration 28 g00432419
Lockup Clutch And Synchronizing Valve (15) Synchronizing valve (33) Spacers
Table 7
Spacer Chart for Synchronization Valve (1)
Spacer Part Number Thickness Change In Pressure
5M-7914
0.25 mm (.010 inch)
10 kPa (1.5 psi)
5M-7915
0.91 mm (.036 inch)
35 kPa (5.1 psi)
( 1 ) Before an adjustment is made, make sure that the valve spring is not weak or broken.Troubleshooting The Differential And Final Drives
Illustration 29 g00431760
Test For The NoSPIN Differential
Note: This test is done before the installation of