CYLINDER AS 6E6633 - Caterpillar

Attach Tooling (A) and a suitable lifting device to Locations (X). The weight of cover assembly (12) is approximately 59 kg (130 lb). Position the cover assembly and install bolts (13) .
Illustration 41 g02475239
Position bearing cage (16) and install bolts (15) .
Illustration 42 g02518336
Typical Example
Illustration 43 g02518716
Note: Rotate the shaft during the end play adjustment in order to seat the bearings properly.
Use Tooling (N) at pump drive Location (N) in order to rotate the shaft. This action will properly seat the bearings prior to checking the end play.
Attach Tooling (D) and a suitable lifting device to the shaft assembly. Apply a slight lifting tension to the shaft assembly. Use Tooling (L) in order to check the end play of the shaft assembly. The end play should be between 0.050 mm (0.0020 inch) and 0.100 mm (0.0039 inch). Add or remove shims as required.
Illustration 44 g02687398
Reinstall the bearing cage using Tooling (C) to install lip seal and the O-ring seals.
Illustration 45 g02518416
Install yoke (7), O-ring seal (4) (not shown), retainer (6), and bolt (5) .
Install tube assembly (14) .
If needed use Tooling (A) and a suitable lifting device in order to reposition the transmission. The weight of the transmission is approximately 1315 kg (2900 lb).
Illustration 46 g02387596
Position yoke (11), O-ring seal (8) (not shown), retainer (10), and install bolt (9) .
Illustration 47 g01270685
Lubricate lip seal (148) with the lubricant that is being sealed. Install lip seal (148) into seal ring housing (146) .
Illustration 48 g01270632
Lubricate O-ring seals (147) with the lubricant that is being sealed. Install O-ring seals (147) into seal ring housing (146) .
Illustration 49 g01279115
Install seal ring housing (146) and bolts (145) .
Illustration 50 g02519020
Lubricate ring seals (53) with the lubricant that is being sealed. Install ring seals (53) onto seal carrier (61). Position seal carrier (61) and install bolts (60) .
Lubricate ring seals (53) with the lubricant that is being sealed. Install ring seals (53) onto seal carrier (87). Position seal carrier (87) and install bolts (86) .
Lubricate ring seals (53) with the lubricant that is being sealed. Install ring seals (53) onto seal carrier (114). Position seal carrier (114) and install bolts (115) .
Install the covers and O-ring seals.
Illustration 51 g02440856
Position Yoke (51), O-ring seal (not shown), retainer (49), and install bolt (50) .
Illustration 52 g02359576
Lubricate the input speed sensor O-ring seal with the lubricant that is being sealed prior to installation. Position harness assembly (3) and connect the harness assembly.
Install bolts (1) and (2) .