CYLINDER AS 7J9222 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Inspect the O-ring seals, the seals, and the gaskets. Replace the O-ring seals, the seals, and the gaskets that are worn or damaged.Note: Lubricate O-ring seals lightly with the lubricant that is being sealed.
Illustration 1 g01844433
Install O-ring seal (25).
Illustration 2 g01844423
Install gear pump (24). Install bolts (23). Tighten bolts (23) to a torque of 55 10 N m (41 7 lb ft).
Illustration 3 g01844421
Install housing (22) and install bolts (21). Tighten bolts (21) to a torque of 55 10 N m (40 7 lb ft). Install tube assembly (20) and tube assembly (19). Note: Tighten tube assembly (20) to a torque of 42 2 N m (31 2 lb ft). Tighten tube assembly (19) to a torque of 172.5 7.5 N m (127 6 lb ft).
Illustration 4 g01844416
Install seal (18), O-ring seal (17), and O-ring seals (16).
Illustration 5 g01844394
Illustration 6 g01841313
Install oil pan (15). Install bolts (14) and bolts (13). Tighten bolts (14) to a torque of 28 7 N m (21 5 lb ft).
Tighten two of bolts (13) that are marked with an X to a torque of 28 7 N m (21 5 lb ft).
Tighten the remaining bolts (13) to a torque of 55 10 N m (41 8 lb ft).
Illustration 7 g01843774
Connect harness assemblies (12).
Illustration 8 g01843733
Install guard (11). Install bolts (10). Install bolts (10) to a torque of 28 7 N m (21 5 lb ft).
Illustration 9 g01843642
Install screen (9) and magnetic filter (8).
Illustration 10 g01843639
Install O-ring seal (7).
Illustration 11 g01843638
Install cover (6) and bolts (5). Tighten bolts (5) to a torque of 28 7 N m (21 5 lb ft).
Illustration 12 g01843618
Install output shaft (4) and bearing assembly (3). Install retaining ring (2) and retaining ring (1). End By:
Connect the transmission onto the engine. Refer to Disassembly and Assembly, "Engine, Torque Converter, and Transmission - Connect".