CYLINDER AS 8J9431 - Caterpillar

Install wires from harness (12) into the correct contactors (10).
Illustration 17 g03872465
View of wire installation
Plug the wires into the correct contact block terminals.
Illustration 18 g03872482
View of wire assembly installation
(X) AC706
(Y) AC765
(Z) AC701
(AA) AC751
(AB) AC702
(AC) AC752
(14) 479-9295 Wire As
Install left wire assembly (14) and install wires into the correct relays and correct terminal slot.
Illustration 19 g03872488
View of wire assembly installation
(AD) AC703
(AE) AC753
(AF) AC704
(AG) AC754
(AH) AC705
(AI) AC755
(15) 479-9296 Wire As
Install right wire assembly (15) and install wires to the correct relay and the correct terminal slot.
Illustration 20 g03872467
View of ground wire installation
(13) green/yellow ground wires
Make sure that all green/yellow ground wires are hooked up.
Illustration 21 g03872499
View of seal installation
(16) 5P-7211 Seal
(17) 482-3501 Plate
Install seal (16) on to plate (17). Cut two seals (16) to a length of 39.5 mm (1.6 inch) for the sides and one 313 mm (12.3 inch) long for the top.
Illustration 22 g03872505
View of plate installation
(17) 482-3501 Plate
(18) 8T-4138 Bolt
Install plate (17) on the back of box that will hold the rubber flashing. Use two bolts (18) to hold the box and the plate.
Reinstall the box in the screed using the two existing bolts on the bottom.
Illustration 23 g03872509
Install the screed harness heater wires into the box then plug wires into the correct contact blocks.
Illustration 24 g03872520
View of heat shrink tubing
(19) 125-7875 Heat Shrink Tube
Cut heat shrink tubing (19) to 30 mm (1.2 inch) for each wire that was taken out of the Deutsch connectors that came from the generator, and install on wire.
Illustration 25 g03872526
Install the wires that are coming from the tractor generator to the correct connector terminal block.
Illustration 26 g03872533
View of terminal jumpers to be removed
Remove terminal jumpers if installed on a 35kW machine. Note: Please note what generator you have before continuing on with this step.
Illustration 27 g03872554
View of cover installation
(20) 7X-0818 Bolt
(21) 8T-4224 Hard Washer
(22) 479-6688 Cover As
Install two bolts (20) and two washers (21) on cover (22).
Reinstall top cover using three bolts (23). Note: Use 8T-4137 Bolts when reinstalling top cover.
Turn breakers back on, and check operation.