CYLINDER AS 8R1214 - Caterpillar

8R1214 CYLINDER AS Caterpillar parts IT12B, IT14B, IT14F

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA8R1214
8R-1214
8R1214

Weight: 20 pounds 9 kg.

Buy CYLINDER AS 8R1214 Caterpillar genuine, new aftermarket tractor parts with delivery
INTEGRATED TOOLCARRIER,

This part in 3 request: Show. This information for suppliers only!

#922262 8R1214

2022-07-06

#295872 8R1214

2019-04-11

#57772 8R1214

2017-04-25

Compatible equipment models: 8R1214:

INTEGRATED TOOLCARRIER IT12B IT14B IT14F Caterpillar

Number on catalog scheme: 5

Caterpillar 8R1214 Parts scheme CYLINDER AS

For full view, you need register

Information:

Illustration 23 g00613569
Remove thrust washer (30) from bevel gear (29) .
Illustration 24 g00632313
Place Tooling (G) into position on carrier (18) . Place bearing caps (17) into position. Install the bolts and the washers that secure the caps.Note: Tooling (G) prevents the bevel pinion shaft from falling during the removal of the pinion.
Illustration 25 g00632318
Tighten the screw on Tooling (G) until the screw contacts bevel pinion shaft (31) .
Illustration 26 g00614236
Rotate carrier (18) by 180 degrees. Remove the bolt and the washer that secures yoke (32) .
Illustration 27 g00614241
Remove O-ring seal (33) from yoke (32) .
Illustration 28 g00614133
Remove the six bolts and the washers that secure seal retainer (34) . Remove the seal retainer. Remove the O-ring seal from the seal retainer.
Illustration 29 g00614137
Use Tooling (E) and a hammer in order to remove seal (35) from seal retainer (34) .
Illustration 30 g00614145
Use Tooling (H) in order to lift the staked portion of nut (36) .Note: If nut (36) is equipped with set screws, loosen the set screws. Tooling (H) is not needed.
Illustration 31 g00620884
Install the yoke onto pinion shaft (31) . Install two 1/2 in. - 20 bolts to the yoke. Use a pry bar in order to hold the yoke while you remove nut (36) .Note: If nut (36) is equipped with set screws, use Tooling (J) in order to remove nut (36) .
Illustration 32 g00614198
Remove washer (37) from shaft (31) .
Illustration 33 g00632333
Remove bearing (38) from cage (39) .
Remove the ten bolts and the washers that secure cage (39) to the carrier.
Illustration 34 g00632387
Install two M10 - 1.5 forcing bolts (40) to cage (39) . Remove the cage from carrier (18) . Remove the O-ring seal from the cage.
Use Tooling (E) and a hydraulic press in order to remove the bearing cup from cage (39) .
Illustration 35 g00614222
Rotate the carrier by 180 degrees. Use a hammer and Tooling (E) in order to remove bearing cup (41) from carrier (18) . Remove the shim pack that is located under the cup.
Illustration 36 g00617105
Use Tooling (F) and a hydraulic press in order to remove bearing (42) from pinion shaft (31) .