CYLINDER A. 8S7650 - Caterpillar

START BY:a) remove cylinder headsb) remove direct injection adapters 1. Put springs (1) in compression with tool (A).2. Remove locks from valves.3. Remove tool (A), rotocoil, spring and valve. If valves can be used again, put identification on the valves for location at installation. 4. Check the spring force with tool (B). Spring force must be 344 34 N (77.5 7.5 lb) when the length of spring under force is 54.99 mm (2.165 in).5. Do Steps 1 through 4 again for the remainder of the valves.Install Valves
1. Put clean engine oil on the valve stem. Install spring (2), rotocoil (1) and valve. 2. Put the springs in compression with tool (A).3. Install locks (3) with the thick end up.
Locks can be thrown from the spring compressor when released. To prevent possible personal injury, slowly release the spring compressor and make sure the locks are in their correct position.
4. Remove compressor and hit valve with a soft faced hammer to be sure the locks are in their correct position.5. Do Steps 1 through 4 again for the remainder of the valves.END BY:a) install direct injection adaptersb) install cylinder heads