CYLINDER AS 9T0579 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 136-1452 Retaining Ring Pliers As 1
B 6V-3175 Double Acting Cylinder 1
3S-6224 Electric Hydraulic Pump 1
9U-5267 Puller Stud 1
2J-3507 Nut (1 inch by 8) 1
3K-5234 Hard Washer 1
6V-2098 Press Sleeve 1
FT2802 Plate 1
D 1P-0520 Driver 1
E 4C-4032 Bearing Mount 1
F 1P-1836 Bearing Puller Adapter 1
6V-3175 Double Acting Cylinder 1
3S-6224 Electric Hydraulic Pump Gp 1
5P-4184 Stud 1
9U-6832 Nut 1
4K-0684 Hard Washer 1
Make sure that the sealing surfaces of the seals and of the equalizer bar are smooth and clean.
Illustration 1 g01261050
Use Tooling (A) to install retaining ring (7).
Illustration 2 g00820096
Illustration 3 g01261052
Use Tooling (B) to install bearing (9) until the bearing contacts retaining ring (7). Make sure that bearing (9) is oriented square to the bore before you apply pressure with Tooling (B).
Use Tooling (A) to install retaining ring (7) in the equalizer bar.
Apply Tooling (E) to the outside surface of seals (8). Use Tooling (D) to install seals (8) in the equalizer bar.
Repeat Steps 2 through 5 on the other end of the equalizer bar.
Illustration 4 g01261056
Place center bearing (10) in position. Make sure that bearing (10) is oriented square to the bore before you apply pressure.
Illustration 5 g01261061
Use Tooling (F) to install two bearings (9) even with the front of the equalizer bar.Note: You must adjust Tooling (F) several times during the installation of the center bearing.Note: The seals for the center pin are different sizes. Make sure that the seals are installed in the correct bores.
Illustration 6 g01261062
Apply Tooling (E) to the outside surface of seals (6).
Use Tooling (D) to install seals (6).
Illustration 7 g01261066
Install plug (2), fitting (4), and O-ring seal (3).End By:
Install the equalizer bar. Refer to Disassembly and Assembly, "Equalizer Bar - Install".