CYLINDER GP-STEERING 9T1834 - Caterpillar

Procedure to Tilt the Cab
Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Do not go beneath cab unless cab is empty and support lever is engaged.Failure to follow the instructions or heed the warnings could result in injury or death.
Note: Empty the water tank (if equipped) before you tilt the cab.
Illustration 1 g00601508
Illustration 2 g00597525
Remove nut (1) and large washer (2) from the inside of the cab.
Illustration 3 g00597551
Remove bolt (3) .
Repeat Steps 1 and 2 on the opposite side of the cab.
Illustration 4 g00597554
Raise cab (4) .
Illustration 5 g00601451
Illustration 6 g00563598
Engage cab support lever (5) .Lower Procedure
Illustration 7 g00601456
Illustration 8 g00563674
Tilt the cab upward.
Disengage cab support lever (5) .
Illustration 9 g00601528
Lower cab (4) .
Illustration 10 g00597551
Install bolt (3) .
Illustration 11 g00601508
Illustration 12 g00597525
Note: Ensure that the large washer is between the nut and the rubber mounting.
Install large washer (2) and nut (1) from the inside of the cab. Tighten the nuts to a torque of 125 10 N m (92 7 lb ft).
Repeat Steps 4 and 5 on the opposite side of the cab.