CYLINDER GP-ARTICULATION 9T2447 - Caterpillar

Removal Procedure
Start By:
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly Manual, "System Pressure - Release".
Remove the refrigerant condenser. Refer to Disassembly and Assembly Manual, "Refrigerant Condenser - Remove".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01171068
Disconnect hose assemblies (1), (2), and (4) from bank valve (3) .
Illustration 2 g01171069
Disconnect hose assemblies (5) and (7) from bank valve (3) .
Disconnect harness assembly (6) from bank valve (3) .
Illustration 3 g01171072
Disconnect hose assemblies (8) and (11) from bank valve (3) .
Disconnect harness assembly (9) from bank valve (3) .
Remove bolts (10) from bank valve (3) .
Attach a suitable lifting device to bank valve (3). Remove bank valve (3). The weight of bank valve (3) is approximately 43 kg (95 lb).