CYLINDER AS 9T2638 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-9760     Stand     1    
Illustration 1 g00678184
Install four metal tubes (11), (12), (13) and (14) to the boom. Install four hoses (15), (16), (17) and (18) to the boom.
Illustration 2 g00648726
Use two nylon straps. Attach one nylon strap to each end of the boom. Attach the nylon straps to a suitable lifting device. Install the boom in position on the machine.
Illustration 3 g00648736
Install two pins (20). The pins will secure the boom to the machine frame. Install two bolts (19). Note: One bolt and one pin are located on each side of the machine.
Illustration 4 g00648697
Install Tooling (A) in position under the front portion of the boom.
Illustration 5 g00648714
Connect hydraulic hose (8) and (7) .
Install hose clamp (6). Secure hose clamp and hydraulic hoses (7) and (8) with bolt (5) .
Illustration 6 g00648718
Install wire (10) in position. Secure wire (10) with eight wire tie-wraps (10) .
Illustration 7 g00648703
Connect hydraulic hose (4) and (3) .
Install hose clamp (2). Secure hose clamp (2) and hydraulic hoses (4) and (3) with bolt (1) .End By:
Install the lift cylinder. Refer to Disassembly and Assembly, "Lift Cylinder - Remove and Install".
Install the tilt lever. Refer to Disassembly and Assembly, "Tilt Lever - Remove and Install".
Install the tilt link. Refer to Disassembly and Assembly, "Tilt Link - Remove and Install".
Install the tilt cylinder. Refer to Disassembly and Assembly, "Tilt Cylinder - Remove and Install".
Install the quick coupler. Refer to Disassembly and Assembly, "Quick Coupler - Remove and Install".
Start the engine. Purge all air from the hydraulic system. Check the fluid level of the hydraulic tank.