CYLINDER AS 9T2898 - Caterpillar

Connecting a Computer to the Product Link System
Required Software
Verify that Product Link has installed the latest flash file.Supported Connections for Hardware
The PL121SR Radio and PL300 ECM are configured with CAT ET by using the following communications interfaces:PL121SR Installations Only - The 245-7310 Control Harness Assembly (Serial Service Cable) is connected between the PC serial port and the serial service connector on the radio legacy harness or the conversion harness. The CAT ET "Communications Interface Device" is configured for "Embedded Communications Adapter".PL121SR plus the PL300 Installations Only - The 171-4400 Communication Adapter Group hardware is connected between the machine service connector and the PC serial port or parallel port. The CAT ET "Communications Interface Device" is configured for the "Caterpillar Communications Adapter II (RP1210)".Note: The configuration parameters for the "Communications Interface Device" are found in CAT ET under "Utilities" menu, "Preferences" drop-down menu.Configure Computer Interface Communications for CAT ET
The following examples of screens show configuring communications for the computer in order to use CAT ET.
Use the 245-7310 Serial Service cable to connect a computer with the required CAT ET software to the serial service connector of the wiring harness.
Select "Utility" on the tool bar.
Illustration 1 g01361214
"Preference" Section for CAT ET
From the drop-down menu, select "Preference".
Illustration 2 g01361220
"Preference" Section for CAT ET
From the "Communications" tab, click the drop-down menu and select "Caterpillar Embedded Communication Adaptor". Configure Product Link PL121SR Radio and PL300 ECM
This section provides information for the user in order to configure the parameters required for the Product Link system during installation. After the "Machine Serial Number","Machine Make Code", and the "Dealer ID" are set, the unit will auto-register the Product Link system.There are a number of parameters that need configured for the Product Link. There are default values that are loaded. Many of the default values are acceptable in most applications. However, care must be followed in setting these parameters to ensure proper operation. Also, care will help avoid increased costs for messaging. Enter the "Product Link Module (PLM) Installation Parameters" last to ensure proper registration. Select the configuration screen by selecting the icon on the tool bar or by using the pull-down menus from the menu bar.Two communications adapters are available in order to flash program the electronic control modules. The 7X-1700 Communications Adapter can be used, or the 171-4400 Communication Adapter II can be used. After the Product Link has been configured, the radio must be registered with the Equipment Manager system. If installing only the PL121SR Radio (no PL300 ECM), configure the radio as described in PL121SR "Installation Parameters Configure - Radio Only" section. If installing the PL121SR and the PL300 ECM, configure the radio and ECM as described in the "Installation Parameters Configure for PL321SR System (PL121SR Radio and PL300 ECM)".
There are three ways to access the configuration screen. Select one of the following options:
Select "Service" and select "Configure" on the menu bar.
Press the "F5" key.
Select "ECM Configuration Icon" on the tool bar.
Ensure that steps have been taken in order to