CYLINDER GP-PIN COUPLER 9T8823 - Caterpillar

Illustration 19 g01383555
Lower the temperature of bearings (40) and (41). Use Tooling (E) in order to install bearings (40) and (41).
Illustration 20 g01383523
Install pin (8) and shims (7). Use Tooling (A) in order to install retaining ring (6). . Install pin (34) and shims (35). Use Tooling (A) in order to install retaining ring (36).
Attach Tooling (B) and a suitable lifting device to boom (37). The weight of boom (37) is approximately 645 kg (1422 lb). Install boom (37). Install pin (39) and any shims that were present. Install bolt (38). Repeat for the other side.
Illustration 21 g01383519
Connect hose assemblies (33) that are routed to the boom.
Illustration 22 g01383483
Illustration 23 g01383495
Attach a suitable lifting device to boom cylinder (29). The weight of boom cylinder (29) is approximately 165 kg (364 lb). Use the suitable lifting device in order to install boom cylinder (29). Install shims (26) and pin (28). Use Tooling (B) in order to install retaining ring (27).
Install pin (31). Install plate (30) and bolt (32).
Illustration 24 g01383479
Install spacer (25).
Illustration 25 g01383476
Install hook (22). Cable assembly (20) was attached to hook (22). Tighten nut (21). Install shims (23) and bolt (24).
Illustration 26 g01383472
Install spacer (19).
Illustration 27 g01383467
Install hook (18) and shims (17). Install bolt (16). Install bracket (15).
Illustration 28 g01383465
Install grease tubes (13) and (14) to the bottom of the boom cylinder.
Illustration 29 g01383448
Place tube assembly (10) and hose assembly (11) into position. Connect tube assembly (12). Install clamp (9).
Illustration 30 g01383426
Attach a suitable lifting device to stick cylinder (5). The weight of stick cylinder (5) is approximately 130 kg (286 lb). Install stick cylinder (5). Install pin (8). Install shims (7). Use Tooling (A) in order to install retaining ring (6).
Illustration 31 g01381777
Connect hose assembly (4). Install clamp (3).
Illustration 32 g01381776
Connect hose assembly (2) to the head end of stick cylinder (1). End By:
Install the stick. Refer to Disassembly and Assembly, "Stick - Remove and Install".