DAMPER GP 2886598 - Caterpillar

Illustration 1 g02671757
(1) Headrest
(2) Seat with Lumbar Support
(3) Lumbar Adjustment
(4) Seat Height Firmness (If Equipped)
(5) Seat Heater (If Equipped)
(6) Air Suspension Switch/Knob
(7) Fore and Aft Adjustment
(8) Seat Backrest Angle Adjustment
(9) Seat Cushion Angle Adjustment
Headrest (1) - Pull up on the headrest to remove extension. The headrest can be pulled forward to support the head at an angle. Pull fully forward to return to the original position.
Lumbar Support (3) - Rotate knob to adjust the lumbar support.
Seat Firmness (If Equipped) (4) - Pull the lever upward to increase the firmness. Push the lever down to decrease the firmness.
Seat Heater (If Equipped) (5) - Push the top of the switch to turn on the heater. Push the bottom of the switch to turn off the heater.
Air Suspension Switch/Knob Raise (6) - Push the left side of the switch to raise the height of the seat. If equipped with the air valve knob, push in the knob to raise the height of the seat.
Air Suspension Switch/Knob Lower (6) - Push the right side of the switch to lower the height of the seat. If equipped with the air valve knob, pull out the knob, to lower the height of the seat.
Fore and Aft Position (7) - Pull the lever upward. Hold the lever upward and slide the seat forward or backward to the desired position. Release the lever to lock the seat into position.
Seat Backrest Angle Adjustment (8) - Pull the lever upward. Hold the lever upward and adjust the backrest to the desired angle. Release the lever to lock the backrest into position.
Seat Cushion Angle Adjustment (9) - To raise the angle of the seat, pull upward on the front of the seat and push the seat rearward. To lower the angle of the seat, pull upward and pull forward.Seat Maintenance Interval Schedule
Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance. Maintenance includes all adjustments, the use of proper lubricants, and the replacement of components due to normal wear and age. Failure to adhere to proper maintenance levels and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: All maintenance from the previous interval must be performed before each consecutive interval is performed.
Table 1
When Required Every 1000 Service Hours or 6 Months
Seat Cushions - Clean/Replace Suspension Bearings - Inspect/Lubricate
Seat Armrest (If Equipped) Pads - Clean/Replace Suspension Adjustable Shock Absorber ( If Equipped) Cable - Check Adjustment
Every 10 Service Hours or Daily Suspension Ride Zone Indicator (If Equipped) - Check Function
Seat Belt - Inspect Every 2000 Service Hours or 1 Year
Initial 250 Service Hours Seat Cushions - Inspect
Slide Blocks - Check Adjustment Seat Back Pan Pivot Nut - Check Tightness
Fore/Aft Stop Bolt - Check Tightness Seat Armrest (If Equipped) Pads