DAMPER AS 3173836 - Caterpillar

Connectors at the Junction Boxes
ECM Junction Box and Connectors for the Engine ECM
Illustration 1 g01707119
Connectors at the ECM junction box (left side engine view)
(J1/P1 and J2/P2) ECM connectors
(1) Timing calibration connector
(2) Termination resistor for the CAN data link
(3) Service tool connector
(4) Connectors for the control harness
(5) Connectors for the detonation sensor harness
(6) Ignition harness
(7) Connectors for the power harness Timing Calibration Connector
Illustration 2 g01155187Connector for the Termination Resistor
Illustration 3 g01707176Connector for the Service Tool Connector
Illustration 4 g01411323Connectors for the Control Harness
Illustration 5 g01707200Connectors for the Detonation Sensors
Illustration 6 g01411150Connectors for the Power Harness
Illustration 7 g01707256Engine Junction Box and Connectors for the Engine Interface
Illustration 8 g01697473
Connectors and terminal locations at the engine junction box
(8) Engine interface connector (30 pin)
(9) 15 amp fuse for the alternator
(10) 10 amp fuse for the throttle actuator
(11) 10 amp fuse for the fuel metering valve
(12) 10 amp fuse for the compressor bypass actuator, electronic control module, advisor monitor display, and the service tool
(13) Connection for the prelube relay (terminal 1)
(14) Connection for the manual prelube (terminal 2)
(15) Jumper terminal for the +Battery to fuse 6 (terminal 3)
(16) Connection for the +Battery to the ECM (terminal 4)
(17) Connection for the +Battery to the service tool connectors (terminal 5)
(18) Connection for the control power that is for the gas shutoff valve from the emergency stop switch to the gas shutoff valve (terminal 6)
(19) Engine interface connector (40 pin)
(20) Connection for the control power that is for the gas shutoff valve from the ECM to the emergency stop switch (terminal 7)
(21) Connection for the keyswitch power that is for the ECM, the exhaust temperature scanner, and the voltage load protection module (terminal 8)
(22) Connection for the −Battery to the compressor bypass actuator (terminal 9)
(23) Connection for the −Battery to the ECM and to the throttle actuator (terminal 10)
(24) Connection for the −Battery to the service tool connectors, to the fuel metering valve, and to the voltage load protection module (terminal 11)
(25) Connection for the keyswitch to the exhaust temperature scanner and to the voltage load protection module (terminal 12)
(26) Interconnect harness connectors for the harness to the advisor module Power Harness Connectors (30 Pin)
Illustration 9 g01708053Engine Interface Connector (40 Pin)
Illustration 10 g01708216