DAMPER AS 7D3013 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-3931     Anti-Seize Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00785171
Put Tooling (A) on the studs for the manifold. Install the gaskets between the exhaust manifold and the cylinder head assembly. Install exhaust manifold (10) . Ensure that the gaskets are in position between the exhaust manifold and the cylinder head assembly.
Illustration 2 g00793378
Install spacers (17) , the washers and nuts (16) that hold the exhaust manifold to the cylinder head assembly. Tighten nuts (16) in the numerical sequence to a torque of 38 5 N m (28 4 lb ft). See the above illustration for the torque sequence.
Illustration 3 g00785166
Install bolts (11) , the nuts, and the washers .
Position two elbows (14) and adapter (15) . Install bolts (12) and (13) , the nuts, and the washers .
Illustration 4 g00785161
Install elbow (9) on exhaust manifold (10) with bolts (7) and (8) .
Illustration 5 g00785157
Install sensor (2) into the block.
Put detonation module (1) in the original location. Install bolts (13) and the washers.
Install fumes disposal tube (6) .
Install spacer (4) , bolt (5) , the nut, and the washer .
Fill the engine with the correct amount of coolant. Refer to Operation and Maintenance Manual.End By: Install oil filter base. Refer to Disassembly and Assembly, "Oil Filter Base - Remove and Install".