DAMPER AS 7E3852 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Fuel System - Prime
Fumes Disposal Filter Element - Replace
Generator - Dry
Generator Bearing - Lubricate
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Rotating Rectifier - Check
Rotating Rectifier - Inspect/Test
Space Heater - Test
Zinc Rods - Inspect/Replace
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Coolant Level - Check
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Filter Differential Pressure - Check
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Generator Bearing Temperature - Test/Record
Generator Load - Check
Power Factor - Check
Stator Winding Temperature - Test
Walk-Around Inspection
Every Week
Electrical Connections - Check
Generator - Inspect
Voltage and Frequency - Check
Initial 250 Service Hours
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust
Speed Sensor - Clean/Inspect
Every 250 Service Hours
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Air Shutoff - Test
Engine Oil and Filter - Change
Every 6 Months
Oil Mist Detector - Clean
Every 1000 Service Hours
Engine - Clean
Engine Crankcase Breather - Clean
Engine Protective Devices - Check
Fuel System Primary Filter - Clean/Inspect/Replace
Gas Pressure Regulator Condensation - Drain
Generator Winding Insulation - Test
Every 2000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine Mounts - Inspect
Flexible Coupling - Inspect
Generator Set Vibration - Test/Record
Stator Lead - Check
Every Year
Coolant Sample (Level 2) - Obtain
Generator Bearing - Inspect
Varistor - Check
Varistor - Inspect
Every 4000 Service Hours
Auxiliary Water Pump - Inspect
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 6000 Service Hours or 6 Years
Air Shutoff Damper - Remove/Check
Alternator - Inspect
Coolant Temperature Regulator - Replace
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Prelube Pump - Inspect
Speed Sensor - Clean/Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Overhaul
Aftercooler Core - Inspect/Clean/Test
Generator Bearing - Replace
Maintenance Recommendations
Overhaul (Major)
Overhaul (Top End)
Overhaul Considerations