DASH ASSEM. 2S2621 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     1    Start By:
Remove the fan group.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01175888
Remove bolts (1) and angle assembly (2) .
Illustration 2 g01175890
Remove bracket assembly (3) and support assembly (4) .
Illustration 3 g01175892
Remove bolts (5) and angle assembly (6) .
Illustration 4 g01175893
Attach Tooling (A) and a suitable lifting device to aftercooler core (7). The weight of aftercooler core (7) is approximately 23 kg (50 lb).
Illustration 5 g01175894
Remove bolts (8) and aftercooler core (7) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 6 g01175893
Illustration 7 g01175894
Use Tooling (A) and a suitable lifting device to position aftercooler core (7) into position. The weight of aftercooler core (7) is approximately 23 kg (50 lb).
Install bolts (8) .
Illustration 8 g01175892
Install angle assembly (6) and bolts (5) .
Illustration 9 g01175890
Install bracket assembly (3) and support assembly (4) .
Illustration 10 g01175888
Install angle assembly (2) and bolts (1) .End By: Install the fan group.