DASH AS 3534566 - Caterpillar

Illustration 1 g01048357
Right side view
Illustration 2 g01048362
Left side view
There may be several specific safety messages on the engine. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiar with all safety messages.Ensure that all of the safety messages are legible. Clean the safety messages or replace the safety messages if the words cannot be read or if the pictures are not visible. When the safety messages are cleaned, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety messages. The safety messages that are loosened could drop off of the engine.Replace any damaged safety messages or missing safety messages. If a safety message is attached to a part of the package that is replaced, install a new safety message on the replacement part. Any Caterpillar dealer can provide new safety messages.
Do not operate or work on this engine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
The safety messages that may be attached on the engine are illustrated and described below.(1) Pinch Point (Linkage)The safety messages for the pinch point (linkage) are located on the covers of the fuel control actuator, the air choke actuator, and the bracket of the exhaust bypass actuator .
Illustration 3 g00123168
During operation, the linkage of the electrohydraulic actuators can form pinch points which can cause personal injury. Shut down the engine before you service the electrohydraulic actuators.
(2) Crankcase CoversThe safety message for the crankcase covers is located on the rearmost crankcase covers.
Illustration 4 g00123185
Flash fire may result in personal injury, if crankcase covers are removed within fifteen minutes after emergency shut down. Do not restart engine until cause for shutdown has been corrected.
(3) Engine Lifting (Label On the Number Three Camshaft Cover and On the Number Four Camshaft Cover)Safety messages for engine lifting are located on the camshaft cover of the number three cylinder and on the camshaft cover of the number four cylinder.
Illustration 5 g00299841
Improper lift rigging can allow unit to tumble causing injury and damage.
(1) Use a proper spreader bar, as shown. (2) Attach two properly rated cables to the spreader bar from the engine lift shackles.(4) Engine Lifting (Label On the Number One Camshaft Cover and On the Number Two Camshaft Cover)Safety messages for engine lifting are located on the camshaft cover of the number one cylinder and on the camshaft cover of the number two cylinder.
Illustration 6 g00299818
Improper lift rigging can allow unit to tumble causing injury and damage.
(1) Use a proper spreader bar, as shown. (2) Attach two properly rated cables to the spreader bar from the engine lift shackles.