6P0987 DASH ASSEM. Caterpillar parts
D9H
Rating:
Alternative (cross code) number:
CA6P0987
6P-0987
6P0987
CA6P0987
6P-0987
6P0987
TRACK-TYPE TRACTOR,
Compatible equipment models: 6P0987:
Number on catalog scheme:
1
For full view, you need register
Information:
Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01125899
Carefully install camshaft (4) in the cylinder block.
Install thrust plate (3) .
If necessary, rotate camshaft gear (1) in order to access thrust plate (3). Install bolts (2) .
Ensure that the No. 1 cylinder is at the top center compression stroke. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
Ensure that the timing marks on the following gears are aligned: the camshaft drive gear, the idler gear and the crankshaft gear.End By:
Install the front cover. Refer to Disassembly and Assembly, "Front Cover - Remove and Install".
Install the rocker arms and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01125899
Carefully install camshaft (4) in the cylinder block.
Install thrust plate (3) .
If necessary, rotate camshaft gear (1) in order to access thrust plate (3). Install bolts (2) .
Ensure that the No. 1 cylinder is at the top center compression stroke. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
Ensure that the timing marks on the following gears are aligned: the camshaft drive gear, the idler gear and the crankshaft gear.End By:
Install the front cover. Refer to Disassembly and Assembly, "Front Cover - Remove and Install".
Install the rocker arms and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".