1754262 DELIMBER AR Caterpillar parts
539
Rating:
Alternative (cross code) number:
CA1754262
175-4262
1754262
CA1754262
175-4262
1754262
KNUCKLEBOOM LOADER,
Compatible equipment models: 1754262:
For full view, you need register
Information:
Start By:a. remove camshaftb. remove flywheel housingc. remove pistons 1. Remove the rear camshaft bearing with Tooling (A).2. Remove the remainder of the camshaft bearings with Tooling (A). Start at the rear of the engine block and move toward the front.Install Camshaft Bearings
1. Install the rear camshaft bearing and three internal camshaft bearings with Tooling (A). Install the bearings from the rear of the block bore. Install the bearings until the front edge of the bearing is even with the front surface (1) of the block bore.
Be sure each bearing is in alignment with the cylinder block bore before the bearing is installed. Install the bearing with the oil hole in alignment with the oil hole in the block bore.
2. Install the front camshaft bearing with Tooling (A) until it is 7.34 0.10 mm (.289 .004 in) from the machined surface on the front of the cylinder block as shown.End By:a. install pistonsb. install camshaftc. install flywheel housing
1. Install the rear camshaft bearing and three internal camshaft bearings with Tooling (A). Install the bearings from the rear of the block bore. Install the bearings until the front edge of the bearing is even with the front surface (1) of the block bore.
Be sure each bearing is in alignment with the cylinder block bore before the bearing is installed. Install the bearing with the oil hole in alignment with the oil hole in the block bore.
2. Install the front camshaft bearing with Tooling (A) until it is 7.34 0.10 mm (.289 .004 in) from the machined surface on the front of the cylinder block as shown.End By:a. install pistonsb. install camshaftc. install flywheel housing