DEMOUNTABLE RIM 3Y8671 - Caterpillar

Illustration 1 g00921400
Schematic of the Indicator Lamp (Ejector Return)
This diagnostic code is associated with the Indicator Lamp (Ejector Return). The FMI 05 means that the ECM has determined that the current of the indicator lamp is below normal. The possible causes of this diagnostic code are listed below:
The energize circuit of the indicator lamp is open.
The return circuit of the indicator lamp is open.
The indicator lamp has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1294 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code occurs, a warning (Category 1) is shown on the monitor. Test Step 1. CHECK THE INDICATOR LAMP.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the indicator lamp with the active diagnostic code from the machine harness.
At the machine harness connector for the indicator lamp, place a jumper wire from contact 1 (wire R748-BR(Brown)) to contact 2 (wire H804-GN(Green)).
Observe the status of the CID 1294 FMI 05. Expected Result:The CID 1294 FMI 05 remains active. The FMI has not changed and the "05" is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The indicator lamp has failed.Repair: The indicator lamp has failed. Repeat this Test Step "CHECK THE INDICATOR LAMP" in order to verify the failure of the indicator lamp. Replace the indicator lamp. Verify that the new indicator lamp corrects the problem.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
The jumper wire that was installed in the previous test remains in place.
At the machine harness connector, measure the resistance from signal contact J2-15 (wire R748-BR(Brown)) to contact J2-13 (wire H804-GN(Green)). Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire R748-BR(Brown) or in wire H804-BK(Black) of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1294 FMI 05. Expected Result:The CID 1294 FMI 05 is active. Results:
YES - The CID 1294 FMI 05 is active. The diagnostic code has not been corrected. The ECM may have