DIFFERENTIAL & BEVEL GEAR GP 1098941 - Caterpillar

Illustration 1 g00901851
Release motion control lever (1) or move motion control lever (1) to the center position. When the motion control lever is in the center position, the brakes will apply. The amber light on the operator station should illuminate.
Engage the parking brake by pushing park brake switch (4) up to the ON position.
If the bucket is empty, lower the bucket to the ground.
If the bucket is loaded, fully tilt the bucket back and lower it to the carry position, approximately 400 mm (15 inch) above the ground.
Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of the engine components.If the engine has been operating at high rpm and/or high loads, run at low idle for at least three minutes to reduce and stabilize internal engine temperature before stopping the engine.Avoiding hot engine shutdowns will maximize turbocharger shaft and bearing life.
Push up engine stop switch (3) until the engine shuts down.
Push down remote shutdown switch (2) to turn off the transmitter. The machine can now be mounted.
Illustration 2 g00946502
Push down remote control switch (5) to turn off the remote control system. The machine can now be operated manually.
If the machine is not going to be operated by remote control for an extended period of time, remove the receiver from the machine and store it in a dry, secure place. This will prevent accidental damage to the receiver.