DIFFERENTIAL GP 1843588 - Caterpillar

Illustration 1 g00688851
Highlight the second line by using the arrow keys. Scroll through the display on the second line until the display shows "CALIBRATION" by using the arrow keys.
Illustration 2 g00689451
Highlight the third line by using the arrow keys. The name of the device for the calibration is displayed on the third line. Scroll through the display until the display shows "PS PRV" by using the arrow keys. The power shift pressure is calibrated for the low pressure and the high pressure.
Low pressure 500 kPa (72 psi)
High pressure 2500 kPa (362 psi)
Illustration 3 g00689455
The area that is highlighted is moved to the right side by using the "menu" key in order to change between low pressure and high pressure. Then, the arrow keys are used in order to change the display from low pressure to high pressure.
Illustration 4 g00689465
Highlight the fourth line by using the arrow keys. Then, change the value. Press the "OK" key.
Illustration 5 g00689483
The fourth line will show a numerical value. The engine speed should be increased to a position of 10 on the engine speed dial. The pressure gauge will indicate the actual power shift pressure. Note the actual value that is shown on the pressure gauge. Use the left arrow key and the right arrow key to enter the value that is shown on the pressure gauge into the fourth line of the display on the monitor. The value should be set as close to the actual pressure as possible. The power shift pressure will change by approximately 30 kPa (4.3 psi) per step. The monitor can correct the pressure by 30 kPa (4.3 psi).
The "setting" key is pressed in order to save the value of the power shift pressure. After the value has been saved, the third line will be highlighted.
Illustration 6 g00689488
Refer to the following table 1 if an error is present on the display. The error will be displayed on the fourth line of the message center.
Repeat the same procedure for the high pressure.
Table 1
List Of Error Codes    
Display     Description Of The Error     Corrective Action    
ERROR 01     Being calibrated by another device     Stop the calibration of the other component. Perform calibration again.    
ERROR 02     Being calibrated by another module     Stop the calibration of the other component. Perform calibration again.    
ERROR 03     Failure of the interlock signal     Troubleshoot the confirmation of the signals for communication.    
ERROR 21     Abnormal component operation     Confirm the active error code. Troubleshoot the problem according to the component.