DIFFERENTIAL & BEVEL GEAR GP 1882009 - Caterpillar

1882009 DIFFERENTIAL & BEVEL GEAR GP Caterpillar parts D6N

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1882009
188-2009
1882009

Caterpillar 1882009 DIFFERENTIAL & BEVEL GEAR GP

Buy DIFFERENTIAL & BEVEL GEAR GP 1882009 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Lenox MGRIT 14 6 1/2X1 1/4 .042 CRSE GULNS (1882009)

$396.33

10 May 2020

-: -

Lenox MGRIT 14 6 1/2X1 1/4 .042 CRSE GULNS (1882009)

Sierra International 18-8200-9 Marine Snapper Clamp, Size 2 - Pack of 10

$9.84

16 Dec 2019
0.017[0.00] Pounds
-: -

Sierra International 18-8200-9 Marine Snapper Clamp, Size 2 - Pack of 10
Clamp Size: 2 || Meets or exceeds the original equipment quality || Sierra part number: 18-8200-9 || Interchangeable with the following: Evinrude/Johnson 322653, OMC 322653, Volvo Penta 3852171 || Clamp Range: .360" - .406" or 9.1mm - 10.3mm

Number on catalog scheme:

Caterpillar 1882009 Parts scheme DIFFERENTIAL & BEVEL GEAR GP

For full view, you need register

Compatible equipment models: 1882009:

TRACK-TYPE TRACTOR D6N Caterpillar

Information:

Illustration 1 g01219226When the electric starting motor is viewed from the drive end, the motor rotates in the following direction. ... ClockwiseNo load conditions at 25 °C (77 °F) Minimum speed with no load ... 7643 1683 rpmMaximum current with no load ... 76.5 14.5 ampVoltage ... 23 V (1) Battery terminal A maximum of three cable or wire terminals should be between the nuts. Tighten the nut on the battery terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (2) Ground terminal Tighten the nut on the ground terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (3) Ground terminal Tighten the nut on the ground terminal to the following torque. ... 2.25 0.25 N m (20 2 lb in) (4) Switch terminal The wire terminal that is on the switch terminal must be insulated with heat shrink tubing. Do not use molded terminals. Tighten the nut on the switch terminal to the following torque. ... 2.25 0.25 N m (20 2 lb in) (5) Motor terminal Tighten the nut on the motor terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (6) Motor frame terminal Tighten the nut on the motor frame terminal to the following torque. ... 8 3 N m (70 27 lb in)Solenoid
Current draw at 20 V and 25 °C (77 °F) Pull-in windings ... 57 AmpHold-in windings ... 16 Amp maximum