DIFFERENTIAL GP 3853587 - Caterpillar

Cut gaskets even with the bottom of front housing and front plate after the housing is installed on the engine.(1) Tighten the two studs to a torque of ... 55 5 N m (40 4 lb ft)(2) Put 5P3413 Pipe Sealant on the threads of the two bolts at assembly. Tighten the bolts to a torque of ... 45 7 N m (33 5 lb ft)(3) Tighten three bolts marked "X" to a torque of ... 45 7 N m (33 5 lb ft)(4) Put 9S3263 Thread Lock on the threads of the two studs at assembly. Tighten the two nuts that hold cover on the studs to a torque of ... 45 7 N m (33 5 lb ft) Ten studs (4) and (5) must be installed to extend above the housing surface to a dimension of ... 26.0 1.5 mm (1.02 .06 in)(5) Put 9S3263 Thread Lock on the threads of the eight studs at assembly. Tighten five studs marked "V" to a torque of ... 35 5 N m (26 4 lb ft).(6) On each of the three studs, put 9S3263 Thread Lock on the stud serrations and each side of the gasket before installation in the timing gear plate and cylinder block. Heads of studs must not be more than 4.5 mm (.18 in) above the surface of the timing gear plate after installation.