DIFFERENTIAL & BEVEL GEAR GP 4932481 - Caterpillar

Illustration 8 g01360821
Press down key (8) until "Forward Currents" is highlighted on the display screen.
Press OK key (9) .
An operator message will be displayed. This message informs the operator that the machine must be moved in the forward direction. Once this has been done, press OK key (9) .
Press OK key (9) in order to begin the calibration.
Illustration 9 g01360822
Move parking brake switch (3) to the ON position.
Rotate speed dial (1) to the midrange position.
Illustration 10 g01426125
Move propulsion mode switch (10) to the PAVE position.
Move propulsion lever (2) to the NEUTRAL position.
Press OK key (9) .Note: If the display does not advance after pressing the OK key, observe the display. Also, ensure that all required conditions are met.
Illustration 11 g01361084
Move parking brake switch (3) to the OFF position.Note: The machine will move during the calibration of the forward pumps.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Move propulsion lever (2) to the FULL FORWARD position.
Press OK key (9) .Note: If the display does not advance after pressing the OK key, observe the display. Also, ensure that all required conditions are met.
Illustration 12 g01361089
The display should now read "Calibrating initial current for forward pumps".Note: At this point, the system is performing the coarse calibration of the initial current for the propulsion pumps.
Illustration 13 g01361105
Move propulsion lever (2) to the NEUTRAL position.
Illustration 14 g01361107
Note: The machine will move during the calibration of the forward pumps.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Move propulsion lever (2) to the FULL FORWARD position.
Illustration 15 g01361109
Display should read "Calibrating initial current for forward pumps".Note: At this point, the system is performing the fine calibration of the initial current for the propulsion pumps.
Illustration 16 g01361111
Move propulsion lever (2) to the NEUTRAL position.
Illustration 17 g01361112
The display should now read "CALIBRATION COMPLETE". Push back key (11) in order to return to the calibration screen.
Push home key (7) in order to exit the calibration screen.
Move parking brake switch (3) to the ON position.
Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Illustration 18 g01426130
After the engine reaches low idle, move engine start switch (12) to the OFF position.