DISC-THRUST 3479389 - Caterpillar

Illustration 3 g00597313
This safety sign is located on the operator console.
No clearance for a man in this area when the machine turns. Severe injury or death from crushing could occur.Install the steering frame lock pin into the locked position before lifting the machine, transporting the machine on another vehicle, or performing service near the center of the machine.Disengage the steering lock pin from articulation joint and store in retainer before resuming operation or the machine will not steer.
Illustration 4 g00666024
Illustration 5 g00597317
This safety sign is located in the steer pivot on both sides of the yoke.
Improper jump start cable connections can cause an explosion resulting in personal injury.Batteries may be located in separate compartments. When using jump start cables, always connect the positive (+) to the positive (+) terminal of the battery that is connected to the starter solenoid and the negative (-) cable from the source to the negative (-) terminal of the starter. (If the machine is not equipped with a starter negative terminal, connect the negative (-) cable to the engine block.) Follow the procedure in the Operation and Maintenance Manual.
Illustration 6 g00038786
Illustration 7 g00597319
This safety sign is located at the rear of the machine on both sides of the machine. The safety signs are located near the battery compartments.
If equipped with an air inlet heater (AIH) for cold weather starting, do not use aerosal types of starting aids such as ether. Such use could result in an explosion and personal injury.
Illustration 8 g00100745
Illustration 9 g00597321
Illustration 10 g00597338
This warning is located on the side of the steering column and on the cover of the air filter housing.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.This structure, when properly installed on a machine which is not altered to exceed the certification test mass meets, at the time of installation, criteria established by: SAE J1040 MAY 94, "ISO 3471:1994"SAE J231 JAN 81, "ISO 3449:1992 Level II".
Illustration 11 g00771480
Illustration 12 g00771362
This warning is located on machines that are equipped with cabs. This warning is located on the rops/fops structure.