DISC-THRUST 4227505 - Caterpillar

Illustration 1 g01344219
Input/Output Cabinet - Left Panel (1) GSM Breaker (1x GSM Option) (2) GSM Breaker (2x GSM Option) (3) Fuse Block F91-F93 (4) Fuse Block (MBP Option) F55, F56 (5) Fuse Block F11, F12 F17-F19 (6) Fuse Block F1-F3 F7-F10 (7) Terminal Block (ESS Option) (8) External Source Sync Board (ESS Option) (9) Fuse Block (ESS Option) F64-F66The External Source Sync (ESS) Terminal Block sits below the External Source Sync Board on the left panel of the Input/Output Cabinet. The terminal block provides a location to wire the external source that is being synced.The terminal block receives the voltage wires and the sync command wires from the J4 connector on the External Source Sync Board via the fuse block and the J7 External Source Sync Connector.Removal
Perform steps in the Systems Operation, Testing and Adjusting, "Internal Component Preremoval Steps (4 Input/Output Cabinet)" in order to de-energize the system and gain access to internal components.
Illustration 2 g01274707
ESS Terminal Block (10) Retaining Clip (11) Mounting Screw (12) Wire Screws
Disconnect the wires that lead to and lead from the terminal block by loosening the wire screws. Refer to Illustration 2. The labels on the wires indicate the location for the wire. Verify the labels on the wires.
Remove the two cross tip screws that secure the terminal block to the left panel.Installation
Slide the terminal block and retaining clips onto the rail.
Attach the terminal block to the left panel in the position that is indicated in Illustration 1. Use two cross tip screws to attach the terminal block. Refer to Illustration 2.
Slide the retaining clips to both sides of the terminal block. Fasten the retaining clips in place with a slotted screwdriver.
Attach wires to the terminal block. The labels on the wires indicate the location for the wire. Refer to Illustration 2.