4479573 DISC-COUPLING Caterpillar parts
Rating:
Alternative (cross code) number:
CA4479573
447-9573
4479573
CA4479573
447-9573
4479573
Weight: 8 pounds 3 kg.
Information:
Improper lifting and improper tie-downs can allow the load to shift or fail and cause injury or damage. Use only properly rated cables and slings with lift and tie down points provided.Follow the instructions in Operation and Maintenance Manual, "Lifting and Tying Down the Machine" for the proper technique for securing the machine. Refer to Operation and Maintenance Manual, "Specifications" for specific weight information.
Illustration 1 g02996562
Illustration 2 g02996560The lift and tie down film (1) is located on all four axles.Lifting the machine
Illustration 3 g02997078
Illustration 4 g02997096The lift and tie down film (2) is located on all four axles.
Lifting Point - In order to lift the machine, attach the lifting devices to the lifting points.The weight and the instructions that are given herein describe the machine as the machine is manufactured by Cat.Refer to the Operation and Maintenance, "Specifications" for specific weight information.Note: Only lift objects from approved lifting points and with approved lifting devices
Use proper rated cables and slings for lifting. The crane should be positioned so that the machine is lifted parallel to the ground.
To prevent contact with the machine, lifting cables should have sufficient length.
Move the hydraulic lockout control to the LOCKED position.
Install the steering frame lock.
Thread the cable around each of four axles.
Apply the proper protector to prevent machine/wire damage and slippage. Tying Down the Machine
There are two methods that can be used to tie down a machine. Local and/or regional regulations will determine which method to use. Note: Obey all local and regional governmental regulations.Tie Down Method
In areas where frictional lashing is not allowed, direct lashing can be used as shown below.
Illustration 5 g02997677
Direct lashing
(A) Front of the machine
(B) Rear of the machine Tying Down the Machine
Tie Down Point - In order to tie down the machine, attach the tie-downs to the tie down points.The weight and the instructions that are given herein describe the machine as the machine is manufactured by Cat.Refer to the Operation and Maintenance, "Specifications" for specific weight information.
Use proper rated cables and shackles for tying down the machine.
Move the hydraulic lockout control to the LOCKED position.
Install steering frame lock.
If there is a requirement of diagonal lashing for tying down, use the proper tie-down point on the lower frame. Set the lashing angle which is on the longitudinal axis of the machine and the cable, at 30 to 50 degrees.
Cat SIS web machinery list:
Parts disc Caterpillar catalog:
2266447
DISC
Caterpillar
Caterpillar
5176830
DISC-TIMING
Caterpillar
Caterpillar
4734793
DISC-FRICTION
Caterpillar
Caterpillar
4710397
DISC-RETAINING
Caterpillar
Caterpillar
4516050
DISC-TIMING
Caterpillar
Caterpillar
0938836
DISC
E110
E110
2559268
DISC-FRICTION
Caterpillar
Caterpillar
5044666
DISC
Caterpillar
Caterpillar
5029811
DISC-COUPLING
Caterpillar
Caterpillar
4932446
DISC-COUPLING
Caterpillar
Caterpillar
4571331
DISC-COUPLING
Caterpillar
Caterpillar
4568373
DISC-COUPLING
Caterpillar
Caterpillar